FULL TABLE REQUIRED FOR COUPLED SETS:
It doesn't make sense to truncate a coupled set by
giving a table length less than 3+NED+NGROUP
because this would remove parts of the n-gamma block.
Increase the table length requested.
REGION INPUT ERROR:
The region temperature has an unreasonable value. Check
your input. This kind of thing can result from a
missing ``/'' on a previous card.
MIX INPUT ERROR:
Either IMIX or IREG has an unreasonable
value. Check your input. Once again, there may be
a missing terminator on a previous card.
NO CONSTITUENT CROSS SECTION MATCH:
The code is unable to find a constituent cross section
with the given material name in the given region.
Check your input.
INCONSISTENT COLLAPSE:
The number of fine groups found by adding up the
NGROUP values given in the collapse
specification (input card 10) must be equal to
the number of fine groups entered in ICOLL
on input card 2.
INCONSISTENT FLUX FILE:
This message usually means that the group structure on
the flux file does not agree with the structure
implied by the TRANSX input file. It may also
mean that this is a three-dimensional flux file.
INCONSISTENT GROUP STRUCTURE:
The number of groups found on the input library for
the various particles are not consistent with the input
quantities NGROUP and NFINE. Sometimes
this means that the wrong MATXS library was mounted.
Otherwise, check the values of the parameters, especially
for complex coupled sets.
STORAGE EXCEEDED FOR LSS:
There is not enough storage available for the
self-shielding calculation. Either reduce the number
of mix specifications and/or the number of groups,
or increase the size of the main container array.
The instructions on how to do this are given at the
beginning of this section.
INSUFFICIENT STORAGE FOR MATERIAL ORDERED FORM:
This message means that not even one Legendre order of
one material can fit in the available storage.
Either change to group ordering (which is more appropriate
for very large group structures), or increase the
size of the main container array. See above.
INSUFFICIENT STORAGE FOR GROUP ORDERED FORM:
This message is unlikely considering the small amount of
memory required to process a single group. It means that
too much storage was consumed in flux arrays and scratch
arrays. The only recourse is to increase the size of the
main container array. See above.
ILLEGAL FORM:
The IFORM variable can only take on the values
1 and 2. Any other value is illegal.
TEMPERATURE OR SIGMA ZERO MISMATCHED:
This message comes from SIGZER. It results from
trying to match the $T$ and $\sigma_0$ values for one
submaterial with the list of possible $T$ and $\sigma_0$
values for all the submaterials in the material. It
should not occur.
SEEK--BAD OPTION hname nop:
This version of SEEK does not handle ``nop'' values
of 4 and 5, nop values outside the normal range 0--7,
or the ``change'' option. This error should not occur
for TRANSX.
SEEK--FILE DOES NOT EXIST hname:
For the ``read seek'' option, the file ``hname'' must
already exist in your local file space.
SEEK--NO UNITS AVAILABLE hname:
Seek assigns unit numbers between 10 and 19. This
error means that more than 10 units are open. It
should not occur for TRANSX.
TRANSX HyperText Manual
TRANSX HyperText Help Package
T-2 Nuclear Information Service